Download Print this page

Troubleshooting; Warranty - RBH Sound Signature Series Owner's Manual

Signature series freestanding speaker
Hide thumbs Also See for Signature Series:

Advertisement

Troubleshooting

Situation:
No sound from
speakers
No sound from
one speaker
Very little bass
and/or imaging

Warranty

Your RBH Sound Signature Series speakers are covered by a limited warranty against
defects in materials and workmanship for a period of five (5) years from the original
date of purchase. This warranty is provided by the authorized RBH Sound dealer
where the speaker was purchased. Warranty repair will be performed only when
your purchase receipt is presented as proof of ownership and date of purchase.
Defective parts will be repaired or replaced without charge by your dealer's store or
the location designated by RBH Sound authorized to service RBH Sound products.
Charges for unauthorized service and transportation cost are not reimbursable
under this warranty. This warranty becomes void if the product has been damaged
by alteration, misuse or neglect. RBH Sound assumes no liability for property
damage or any other incidental or consequential damage whatsoever which may
result from the failure of this product. Any and all warranties of merchantability
and fitness implied by law are limited to the duration of this express warranty.
Some states do not allow limitations on how long an implied warranty lasts, so the
above limitations may not apply to you. Some states do not allow the exclusion
or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you.
Probable Cause:
Speaker wire not connected
Speaker selector on amplifier is
not on
Balance control on receiver
or pre-amp is not centered
Speaker wire not securely
connected
Speakers are wired out of phase
Solution:
Make sure wire is connected
at both the speaker and the
amplifier observing proper
polarity
Activate proper selector on
amplifier
Place balance control in the
center
Check all connections at
amplifier and speakers
Check entire system for proper
polarity and make adjustments
as necessary
1

Advertisement

loading