Applications - Quest Engineering QTA 6060M User Manual

Applications

Quick Start Examples
Example 1
System Paging, BGM, and MOH with Remote
Master Level Control. This application has
the paging microphone into INPUT 1, BGM
(CD player) into Input 2, and a Message
Repeater or MOH into Input 6. The Zone 2
Output is sent to the telephone system's MOH
input port. A level control may be placed in
another area such as a front desk to adjust
the system's level without having to go
the equipment room. When a page comes
through Input 1, the BGM is muted allowing
only paging to be heard through the main
system. The MOH is not affected during the
page.
• Connect a paging mic to INPUT 1. Set
Dipswitch"B" #6, "Input 1" to the "Mic"
position.

Note: The INPUT 1 Trim and Sens will need
to be adjusted after all the settings and
connections have been set.
Dipswitch Settings



Dipswitch 1 - Off (Set To The Required Gain)

Dipswitch 2 - Off (Not Affected)

Dipswitch 3 - Off (Not Affected)

Dipswitch 4 - Off (Not Affected)

Dipswitch 5 - Off (Line)

Dipswitch 6 - On (Mic)

Dipswitch 7 - Depends On Mic Type

Dipswitch 8 - Master
• Connect a BGM (CD) player to INPUT 2. Set
Dipswitch "A" #6, "Mute Rcv" to the "ON"
position Connect a Message Repeater or
MOH device to INPUT 6. Note: The input
gain of this channel may need to be change
for proper level balance. Dipswitch "B"
#1, "Input 6" allows you to select between
a 100mV or 300mV input sensitivity. Turn
down channel 6 gain control on the front
panel.
• Connect Zone 2 output to the MOH input on
your telephone. Adjust the Zone 2 Output
level as needed.
• Connect a wall mount volume control (
Quest p/n AAVCC-10K ) to the terminals
marked "VCA". Set Dipswitch "B" #8, "VCA"
to "Master".
Q-Tech Commercial Series
QTA 6060M/6120M/6250M
QTA 6000 Series
User Manual
Example 1
User Manual
11