Before Initial Use
Charger Wall Mounting
Charger Wall Mounting
1. Install the two included screws in the wall, spacing them 28 mm apart.
2. Mount the charger securely on the wall.
•
Make sure that the wall that the charger will be attached to is strong enough to sup-
port the weight of the handset and charger (270 g [0.6 lb]). If not, it is necessary for
the wall to be reinforced.
•
When this product is no longer in use, make sure to detach it from the wall.
Attaching the Belt Clip and Belt Clip Holder
Attaching the Belt Clip and Belt Clip Holder
You can attach the handset to your belt by following the steps below.
[To attach]
[To remove]
Make sure to turn the handset 180° when you
take it off.
6
Washer
Drive the screw
to this point.
Allows phone straps and similar objects to be connected.
Slide the clip into the holder until it clicks.
28 mm
Screws
Remove the belt clip.