Yamaha TW200V Owner's Manual page 48

PERIODIC MAINTENANCE AND MINOR REPAIR
7. Check the O-ring for damage and
replace it if necessary.
8. Clean the oil filter element with sol-
vent, and then install it.
1
NOTE:
Check the oil filter element for damage
2 and replace it if necessary.
9. Install the oil filter element cover by
3
installing the bolts and the drain
bolt, then tightening them to the
specified torques.
4
Tightening torques:
5
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Oil filter element drain bolt:
6
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
NOTE:
7
Make sure that the O-rings are properly
seated.
8
10. Clean the oil strainer with solvent,
and then check it for damage and
9
replace it if necessary.
11. Install the oil strainer, compression
spring, O-ring and engine oil drain
bolt, and then tighten the drain bolt
to the specified torque.
Tightening torque:
Engine oil drain bolt:
43 Nm (4.3 m·kgf, 31 ft·lbf)
12. Add the specified amount of the
recommended engine oil, and then
install and tighten the oil filler cap.
Recommended engine oil:
See page 8-1.
Oil quantity:
Without oil filter element removal:
1.00 L (1.06 US qt) (0.88 Imp.qt)
With oil filter element removal:
1.10 L (1.16 US qt) (0.97 Imp.qt)
CAUTION:
G
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G Make sure that no foreign mate-
rial enters the crankcase.
6-13
13. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
14. Turn the engine off, and then
check the oil level and correct it if
necessary.
ECA11620