Table of Contents
Advertisement
14. Front Audio Connector
If the housing has been designed with an audio port on the front panel, you'll be able to
connect onboard audio to front panel through this connector. By the way, please remove 5-6
and 9-10 jumper caps from the Front Audio Connector before connecting the cable. Please
do not remove these 5-6 and 9-10 yellow jumper caps if there's no audio port on the front
panel.
AUD_RET_L
AUD_FPOUT_L
KEY
NC
AUD_RET_R
AUD_FPOUT_R
AUD_VCC
AUD_MIC_BIAS
AUD_GND
AUD_MIC
1
Front Audio Connector
15. Power-on and Load BIOS Setup
After you finish the setting of jumpers and connect correct cables. Power on
and enter the BIOS Setup, press <Del> during POST (Power On Self Test).
Del
Choose "Load Setup Defaults" for recommended optimal performance.
Warning: Please avoid of using "Load
Turbo Defaults", unless you are sure
your system components (CPU, RAM,
HDD, etc.) are good enough for turbo
setting.
16. AOpen Bonus Pack CD and EzInstall
You can use the autorun menu of Bonus CD disc. Choose the utility and driver from the
ICON at left side.
Install driver
Install utility
Browse
CD contents
Read me
Exit CD
17. BIOS Upgrade under Windows Environment
You may accomplish BIOS upgrade procedure with EzWinFlash by the following steps,
and it's STRONGLY RECOMMENDED to close all the applications before you start the
upgrading.
1.
Download the new version of BIOS package zip file from AOpen official web site. (ex:
http://english.aopen.com.tw)
2.
Unzip
the
download
BIOS
package
(http://www.winzip.com) in Windows environment.
3.
Save the unzipped files into a folder, for example, WSG4DL102.EXE &
WSG4DL102.BIN.
4.
Double click on the WSG4DL102.EXE; EzWinFlash will detect the model name and
BIOS version of your motherboard. If you had got the wrong BIOS, you will not be
allowed to proceed with the flash steps.
5.
You may select preferred language in the main menu, then click [Start Flash] to start
the BIOS upgrade procedure.
6.
EzWinFlash will complete all the process automatically, and a dialogue box will pop
up to ask you to restart Windows. You may click [YES] to reboot Windows.
7.
Press <Del> at POST to enter BIOS setup, choose "Load Setup Defaults", then
"Save & Exit Setup". Done!
It is strongly recommended NOT to turn off the power or run any application during
FLASH PROCESS.
Click to install
online manual
AOpen
Branches
Information
(ex:
WSG4DL102.ZIP)
with
WinZip
Advertisement
Table of Contents
