INDEX CONTROL OF THE COLLECTOR ELECTRIC MOTORS DRIVE ELECTRIC MOTOR THERMOSTAT PRESSURE SWITCH POTENTIOMETER PUMP HEATER SOLENOID VALVE DOOR SWITCH CONTACTOR TIMER FLOW CHART PRODUCT INFORMATION SHEETS SERVICE EQUIPMENT TROUBLE SHOOTING PARTS LIST AND DIAGRAM...
1. CONTROL OF THE COLLECTOR ELECTRIC MOTORS ON WM WITH EL. REGULATION When rotor of the electric motor comes into short circuit it is likely that the el. regulation will get damaged. It is impossible to check short circuit with the multimeter at the customer due to very low impedance.
3. THERMOSTAT - ADJUSTABLE Typ: 55 13019.103 part number: 078624 alternative part numbers: 550914, 530407 Temperature range: 27.5 – 88 +/- 4 °C Switching capacity: 16(4) A / 250 V Switching difference: 6 +/- 2.5 °C wiring diagram:...
5. POTENTIOMETER Typ: PC 6G 22k log part number: 368306 Resistance range: 0-22 KΩ +/- 10% 6. PUMP - SYNCHRONOUS Typ: part number: 553645 Supply voltage: 208-240 V, 60 Hz Power: 34 W Capacity: 16 l/min at nominal voltage Winding resistance: 95 +/- 7% Ω 7.
Page 9
Working pressure: 0.2 – 10 bar Rated flow: 7 l/min +/-15% Rated power: 8 VA SOLENOID VALVE - DOUBLE Type: ED 180/88 part number: 606715 alternative part numbers: 609396 Supply voltage: 220/240 V, 50/60 Hz Coil resistance: 3700 +/-8% Ω (at 20 °C) Connection of inlet hose: ¾...
Page 10
unlocking: min.35 – max.65 sec. at temperature 20°C after machine switching off wiring diagram: 10. CONTACTOR Type: EBERLE 0419 01 1101 00 part number: 657141 wiring diagram:...
Page 11
11. TIMER Typ: EC 4460 part number: 606713 Nominal voltage: 220 - 240 V, 50/60 Hz Contact capability: 16 (4) A, 250 V Program description: see next page Take into consideration that wash step times are approximately 20% shorter than stated.
Page 15
SERVICE EQUIPMENT FOR SERVICING WASHING MACHINES AND DRIERS NAME DIM. Art. No.: PICTURE (SYMBOLIC) OPEN-END WRENCH 6 x 7 13668 8 x 9 13672 10 x 11 13679 12 x 13 13686 14 x 15 13690 16 x 17 13696 18 x 19 13700 OPEN-END WRENCH - BENT...
Page 16
SERVICE EQUIPMENT FOR SERVICING WASHING MACHINES AND DRIERS NAME DIM. Art.No.: PICTURE (SYMBOLIC ) HAMMER 812/300 14393 RIVETER CL 701 19240 ELECTRIC DRILL 500 W 557987 EL. SCREWDRIVER 9019 484893 HEXAGON WRENCH UNIVERZAL MAGNETIC HOLDER E 6,3 14601 SCREWDRIVER INSERT - CROSSTIP 14598 14280 SCREWDRIVER INSERT - FLAT...
Page 17
SERVICE EQUIPMENT FOR SERVICING WASHING MACHINES AND DRIERS NAME DIM. Art.No.: PICTURE (SYMBOLIC ) MULTIMETER V,Ω, T(-40, +400), µA FLUKE 505828 MAX, MIN SERVICE BAG 018252...
TROUBLE SHOOTING FAILURE DETECTION AND REPAIR General: Always handle the machine highly professionally. Tests and failure detection should be made systematically and in the prescribed order. Always use original wiring diagrams, drawings and timetables. If a failure is not a typical one and you will have to test the washing machine, check the following first: is the washing machine connected to a power supply (the voltage should −...
Page 19
Machine overheating Thermostat button on the Replace damaged water wrong position component, remove the cause Thermostat out of order Machine does not turn Pressure switch does not Replace damaged left-right switch over component, remove the cause Timer damaged Belt torn Motor connection out El.
• DOOR HANDLE SPRING 660138 • DOOR HANDLE 660137 • FRAME OF GLASS DOOR 660135 • INNER DOOR COVER 660136 • DWM5500W FRONT PANEL 660024 • SWM5500W FRONT PANEL 660027 • SOAP DISPENSER HANDLE 660023 • TOP COVER 667030 •...
Need help?
Do you have a question about the DWM5500W and is the answer not in the manual?
Questions and answers