Motor Wiring And Grounding Instructions - Foley United 388 Assembly And Service Manual

INSTALLATION (Continued)
MOTOR WIRING &
GROUNDING INSTRUCTIONS
Your Model 388 Grinder has been completely prewired at
the factory, and no additional wiring is necessary. The Model
388 is set up for a 115 VAC, 50/60 HZ 1 Phase - current.
The grinder operates on a 15 AMP circuit. The wall outlet
should be grounded and look like the outlet shown in
FIG. 14. See FIG. 15 for 115 volt motor wiring, as built.
To convert this grinder to operate on 220 V 50/60 HZ 1 phase
current, cut the plug off from the cord and replace it with the
appropriate plug for your locality. For plug and circuit breaker
sizing, see motor nameplate ratings. Use only a qualified
electrician.
To convert the grinder from 115 Volt to 220 Volt, disconnect
the four wires coming from the motor internally and
reconnect them as shown in FIG. 16. One additional wire
nut will be required to complete. NOTE: This motor will
operate correctly on 60 HZ or 50 HZ power.
GROUNDING INSTRUCTIONS
In the event of a malfunction or breakdown, grounding
provides a path of least resistance for electrical current to
reduce the risk of electrical shock. This tool is equipped
with an electrical cord having an equipment grounding
conductor and a grounding plug. The plug must be plugged
into the matching outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
Before plugging in your machine, make sure it will be
connected to a supply circuit protected by a properly
sized circuit breaker or fuse.
Do not modify the plug provided if it will not fit the outlet,
have the proper outlet and circuit installed by a qualified
electrician.
Always properly electrical ground
your machine. An improper
connection can cause an electrical
shock. If unsure of the proper
electrical grounding procedure,
contact a qualified electrician.
Wiring,
as built.
To convert to
7
7
FIG. 14
FIG. 15
wiring.
FIG. 16