Installation; Removing Doors(Freezer); Attaching Doors - Samsung RS2511 Series Service Manual

2. INSTALLATION

Removing Doors(Freezer)

● ●
Open the freezer and refrigerator doors, and
then take off the front leg cover assembly by
unlocking the hook(upper side:3EA, lower side
:3EA) of the front leg.
With the door closed, remove the upper hinge
cover using a screwdriver, and then disconnect
the wires. Remove hinge screws and ground
screw counter-clockwise, and take off the upper
hinge. Take care removing the door to ensure that
it does not fall on you.
Remove the door from the lower hinge by
carefully lifting the door so as not to damage the
water tube.
1) To protect refrigerator in movement
Use padded hand truck as shown. If entrance width is
less than 39 〃 , remove doors prior to installation and
reattach doors according to procedure below.
2) Remove all protective tape and pad in refrigerators.
Connect water lines and power cord. Adjust the
clearance between the doors.
3) Set the temperature control to the temperature and
wait for an hour.
The refrigerator should get slightly chilled and the motor
runs smoothly.
4) Once the refrigerator temperature is sufficiently low
You can store food in the refrigerator. After starting the
refrigerator, it takes a few hours to reach the appropriate
temperature.

Attaching Doors

● ●
-Freezer : Attach the freezer door by inserting
the hose in the lower side of the door into the hole
in the lower hinge and pulling the hose down.
-Refrigerator : Insert the lower hinge in the
bracket lower hinge. Attach the door to the
cabinet.
Insert the upper hinge shaft into the hole. After
leveling between the upper hinge hole and the
hole of the cabinet. Reattach hinge screws and
screw in the clockwise direction. Connect the
wires. Put the front part of the upper hinge cover
on the front part of the upper hinge( ) and
reattach from the front part of the upper hinge
cover first( ).
5