Burner Tube Cleaning Or Replacement - Weber Go-Anywhere Owner's Manual

BURNER TUBE CLEANING
OR REPLACEMENT
Confirm that Grill Is Off and Cool
A) Check that the regulator control knob is turned off
by pushing it in and turning it clockwise to the OFF
position.
B) Disconnect the LP cylinder.
C) Remove the lid.
D) Remove cooking grate.
Remove Regulator Assembly
A) Remove retaining clip and remove regulator
assembly (1).
Remove Burner Tube
A) Remove wing nut, washer and screw (2).
B) Carefully pull burner tube out and away from
cookbox (3).
Clean Burner Tube
You will need: A flashlight, a wire (a straightened-out coat
hanger) and a suitable stainless steel bristle brush.
A) Look inside the burner tube with a flashlight (4).
B) Clean any debris or blockage from the inside of the
burner tube with the wire (5).
C) Use the stainless steel bristle brush to clean the
outside of the burner tube. This is done to make sure
all burner ports (openings) running along the length of
the tube are fully open (6).
m CAUTION: Do not enlarge the burner
ports when cleaning.
Reinstall Burner Tube
A) Carefully slide the burner tube through the hole in the
right side of cookbox.
B) Reinstall wing nut, washer and screw that secure the
burner tube to the cookbox (hand tighten only).
Reinstall Regulator Assembly
A) Reinstall regulator assembly and secure with retaining
clip.
m DANGER: Do not use the grill if the
retaining clip securing the regulator
and orifice into the burner tube is
missing.
m WARNING: You should check for gas
leaks every time you disconnect and
reconnect a gas fitting.
B) Verify that the tip of the igniter electrode is adjusted
to the proper distance from the holes in the burner
tube. Refer to "MAINTAINING THE PUSH BUTTON
IGNITION SYSTEM" for proper positioning.
C) Reinstall cooking grate.
D) Reinstall the lid.
E) Reinstall the LP cylinder.
ANNUAL MAINTENANCE
1
2
4
5
Meijer.com
3
6
15
WWW.WEBER.COM
®