Xerox Document Centre 555 Setup Manual page 22

7. Type in the line below, substituting the DC 555/545/535's email address for
dc_email_address@my_domain.com
Remember that what you are typing in may not be visible on the screen.
mail from: dc_email_address@my_domain.com
If sucessful, you should see a reply similar to:
250 OK - mail from <dc_email_address@my_domain.com
8. Type in the following line, substituting your real email address for
my_email_address@my_domain.com
rcpt to: my_email_address@my_domain.com
9. If successful, you should see a reply similar to:
250 OK - Recipient my_email_address@my_domain.com
10. Type in the word Data to begin your message:
Data
11. You should see a reply similar to:
354 Send data. End with CRLF.CRLF
12. Type in this line:
subject: Test
13. Now type in some text for the body of the message:
This is a test.
This is only a test.
14. End by typing in a single period on a line by itself.
You should see a reply similar to:
250 OK
15. Type in quit to close the telnet session:
quit
You should see a reply similar to:
221 closing connection
If this simulation succeeded, you will see the test message in your email inbox.
If the simulation failed, check the following:
* verify the email server IP address
* verify valid email addresses
* avoid typos
Page 20
Simple Scan to Email Setup Guide May 2004