V-Belt - Yamaha PZ50RTZ Owner's Manual

1. "COLD LEVEL" mark
2. Coolant reservoir cap
Recommended antifreeze:
High-quality ethylene glycol antifreeze
containing corrosion inhibitors
Antifreeze and water mixing ratio:
3:2
Total amount:
PZ50GT 3.60 L (3.81 US qt,
3.17 Imp.qt)
PZ50MT 3.60 L (3.81 US qt,
3.17 Imp.qt)
PZ50RT 3.60 L (3.81 US qt,
3.17 Imp.qt)
PZ50VT 3.70 L (3.91 US qt,
3.26 Imp.qt)
4. Start the engine, allow it to idle for several
minutes, and then turn it off.
5. Check for any coolant leakage.
TIP
If you find any leaks, consult a Yamaha deal-
er.
Periodic maintenance and adjustment
6. Install the right upper cover, and then in-
stall the top cover (PZ50RT / PZ50GT /
PZ50MT) or close the shroud (PZ50VT).
ESU12083

V-belt

EWS00401
WARNING
Coming in contact with the rotating V-
G
belt or clutch parts can cause severe in-
jury or death. Never run the engine with
the drive guard removed.
Make sure that the drive guard is tight-
G
ened securely before operating the
snowmobile to protect against severe
injury or death from a broken V-belt or
other part should it come off the snow-
mobile while it is in operation.
ECS00830
NOTICE
Never run the engine with the V-belt re-
moved. Clutch components can be dam-
aged.
The V-belt should be checked before each
ride.
To check the V-belt
1. Remove the left side cover (PZ50RT /
PZ50GT / PZ50MT), or open the shroud
and remove the left upper cover and the
left side cover (PZ50VT). (See page 48
for removal procedure.)
2. Remove the drive guard.
3. Check the V-belt for wear and damage.
Replace if necessary.
61