Table of Contents
Advertisement
4. Ventilation and installation
To ensure adequate ventilation for your refrigerator,
allow a minimum of 20 mm of airspace on each side of
the cabinet, 75 mm at the rear, and 50 mm at the top of
the cabinet.
The appliance is intended to be placed against a wall
with a free distance not exceeding 75 mm.
5. Fitting the handles
Your refrigerator is supplied with a set of handles,
4 handle attachment studs and 4 small handle screws.
To fit the handles
Insert the handle attachment stud into the fixed
1
threaded holes (fig.2a) found on the front of each
compartment door and tighten using the Allen key
provided in a clockwise direction.
Align and fit the handle on to the handle attachment
2
studs (fig.2b).
Using the Allen key, tighten the small handle screws
3
fitted to the inside of the wider handle end (fig.2c).
Install the 2nd handle in the same way (see fig.2d).
4
Energy efficiency
Do not cover your appliances with any material that will
prevent air from flowing around the cabinet sides.
Do not leave the door open for any longer than is
necessary.
Allow good clearances in front of the air ducts within the
cabinet for maximum cold air distribution.
Installation instructions
Fig.2a Fixed threaded stud hole and
Fig.2b Align handle to the handle
Fig.2c Tighten the handle screw with
Fig.2d Install the 2nd handle
handle attachment stud
attachment stud
Allen key
5
Hide quick links:
Advertisement
Table of Contents
