Luminance
Contrast
Contrast from Digital-register.
Brightness
Backlight Adjustment.
Image Setup
Focus
Adjusts Picture Phase to reduce Horizontal-Line
noise.
Clock
Adjusts picture Clock to reduce Vertical-Line noise.
Image Position
H. Position
Adjusts the horizontal position of the picture.
V. Position
Adjusts the vertical position of the picture.
Color Temp.
Warm
Recalls Warm Color Temperature from EEPROM.
Cool
Recalls Cool Color Temperature from EEPROM.
sRGB
Recalls sRGB Color Temperature from EEPROM.
User/Red
Red Gain from Digital-register.
User/Green
Green Gain Digital-register.
User/Blue
Blue Gain from Digital-register.
Auto Config
Yes
Auto Adjusts the H/V Position, Focus and Clock of
picture.
No
Does not execute Auto Config, returns to main
menu.
OSD Setup
H. Position
Adjusts the horizontal position of the OSD.
V. Position
Adjusts the verticalposition of the OSD.
OSD Timeout
Adjusts the OSD timeout.
Language
Language
Sets OSD language.
Information
Information
Shows the resolution, H/V frequency, serial number
and input port of current input timing.
Reset
Yes
Clear each old status of Auto-configuration.
No
Do not execute reset, return to main menu.
Exit
Exits OSD.
OSD Message:
Auto Config Please Wait
If User Press Hot-Key "Auto", will show this message,
and the monitor do the auto configuration function.
This message location is at the position setting in
"OSD Setup" item.
Input Not Supported
When the H sync Frequency, V sync Frequency or
Resolution is out of the monitor support range, will show this
message. This message will be flying.
Cable Not Connected
When the video cable is not connected, will show this
message. This message will be flying. After 5 seconds, the
monitor will enter power saving.
No Signal
When the video cable is connected, but there is no active
signal input, will show this message, after 5 seconds the
monitor will enter power saving. This message location is at
the position setting in "OSD Setup" item.
English-7