Section 3 -4 Venting Components - Montigo R520 Installation & Maintenance Manual

Section 3-4: Venting components
The following components and associated Montigo part numbers are for
installation of a roof or wall mounted Power Vent. Only use Montigo Vent
Components. Use of non-Montigo parts will VOID the warranty and may impede
operation of the fireplace.
a - Termination
B - Frame Kits
C - Flex Sections
D - Rigid Sections
E - Elbows
F - Support Ring & Plate RSPXT-10
G - Firestop
H - Heat Shield
XG0771 - 040513.3
Installation
EPVRR (Roof Mount 5"/10")
EPVRw (wall Mount 5"/10")
EPVRRF (Roof Mount 5"/10")
EPVRwF (wall Mount 5"/10")
RFL1 (12" f/f Section)
RFL2 (24" f/f Section)
RFL3 (36" f/f Section)
RFL4 (48" f/f Section)
RFL6 (72" f/f Section)
RXT - 10 (10" f/f Section)
RXT - 20 (20" f/f Section)
REXT - 1 (12" f/m Section)
REXT - 2 (24" f/m Section)
REXT - 3 (36" f/m Section)
REXT - 4 (48" f/m Section)
REXT - 6 (72" f/m Section)
REL-90MM (m/m 90º Elbow)
REL-90FF ( f/f 90º Elbow)
REL-90FM ( f/m 90º Elbow)
REL-45FM ( f/m 45º Elbow)
FS-10
RHS102
R520 & R620 Power Vent Indoor Gas Fireplace
Connection and installation of the vent components should
adhere to the following guidelines:
Use any combination of rigid and flex pipe as required and in
„
any orientation (Male connectors can face in any direction).
Flex sections may be stretched up to 50% of their total length
„
(e.g. a 24" section maybe stretched to 36").
Ensure the pipe ends male to female slide in a minimum of
„
1 1/2" of overlap.
Connect all vent sections using a minimum of three sheet
„
metal screws on the outer pipe flue.
Ensure all runs are supported with a minimum of 3 supports
„
per 10' of venting.
When hanging/ supporting venting, ensure that 1" clearance
„
is maintained on sides and bottom of vent runs and 2" above
horizontal vent runs to any combustible material.
Rigid pipe may be cut less than half way from the female
„
end only.
Ensure when cutting sections of rigid pipe to maintain integrity
„
of internal supports.
Place the springs, supplied with the pipe kit, between the
„
outer and inner pipes to keep the pipes separate and avoid
any possible hot spots.
Montigo recommends the use of a flex section for the final pipe
„
connected directly to the fireplace offering greater flexibility
of installation and absorption of movement.
Firestops must be installed as required by National & local
„
codes.
Montigo recommends that all exterior corners and joints be
„
sealed with exterior caulking. However, we encourage you
to consult your Building Envelope Engineer or Waterproofing
Consultant for further recommendations.
IMPORTANT:
Please Refer to your Building Envelope
Engineer or Waterproofing Consultant
for a review of ALL penetrations through
exterior walls or the roof.
Page 23