Programming, Cleaning And Maintenence - Nieco ExVection 6220 Owner's Manual

PROGRAMMING
PROGRAMMING
Use the buttons to change settings.
To program the time and heat, hold down the button you
wish to program for 3 seconds.
4
The display will show
This is the top heat setting, 0 is off and 20 is the
maximum setting. For most products, set to 20.
Push the button again to change the bottom heat.
4
The display will show
This is the bottom heat setting, 0 is off and 20 is the
maximum setting. For most products, set to 20.
Some toasters are top heat only, and do not have
bottom heaters.
Push the button again to change the speed.
4
The display will show
This is the time, in seconds, that it takes to toast.
Push and hold the button for 3 seconds to save changes.
4
The display will show
This means the changes have been saved.
CLEANING AND MAINTENENCE
Tools
Instructions
1. Wait for toaster to cool
2. Remove the front guard.
3. Lift belt and brush the area between the belt.
4. Remove the crumb pan.
5. Wipe the cavity of the toaster.
20 20
0 0
13 13
>++< >++<
.
Note: The speed can be
changed temporarily by
using the up or down
arrows but will default
to programmed settings
when a preset button is
pressed. Permanent
speed changes must be
done in programming
mode.
7
Nieco Corporation - ExVection Toaster 6220
2
3
4
5