Advertisement
• Goliath Senior 6x10
• Big Bertha 2x15
• Henry The 8x8
• 12-Stack 4x12
• Workingman's Tower 8x10
Recommended SWR Speaker combinations for use with the 750x include (all are 8 ohm models):
• (2) Goliath III 4x10s
• (2) 12-Stack 4x12s
• (2) Son Of Bertha 1x15s
• (1) Goliath III 4x10 & (1) Son Of Bertha 1x15
• (1) Goliath III 4x10 & (1) Big Ben 1x18
• (1) Goliath III 4x10 & (1) Goliath Junior III 2x10
Speaker Fuse
The speaker fuse is provided to protect your speakers in the unlikely event of a power amp failure or to
protect your power amplifier from incorrect speaker impedances or hookups. Size and rating of the fuse is
3AG, 10 amp, fast-blo. Do not defeat the purpose of this feature by using a higher rated fuse as it can
damage your amplifier and void your warranty.
The fuse can open as a result of a fault in the speaker cable, the speakers themselves, or the power amp
being sent well into clipping. With this in mind, it is wise to carry extra fuses at all times.
Line Fuse (A/C or Mains Fuse)
This fuse is provided to protect the internal electronics against power surges, etc. It also protects the unit
against itself should one of the internal components fail. If this fuse should open, replace it with the same
type of fuse and rating. Do not defeat the purpose of this feature by using a higher rated fuse as it can
void your warranty.
Proper size of the A/C fuse for all countries is 3AG. Proper rating of the fuse is as follows:
United States: 10 amp slo-blo
Japan: 10 amp slo-blo
Europe (230V-240V): 5 amp slo-blo
A/C Cord Receptacle
This receptacle accepts a standard A/C power cable (supplied with the 750x in the United States) used
with almost all current musical, professional and household electronic devices. We recommend great care
when packing up. If your unit is not in a rack case, put the cable in your instrument or accessory case or
leave it attached and looped around one of the rack handles. If it does become misplaced, a replacement
cable can be purchased at almost any music or computer store.
Note: The rating for this cable is 3 conductor, 10 amperes minimum. Look for this rating on the cable.
Make sure the cable is plugged in all the way in both the amp and the wall socket.
Internal Feature: Vacuum Tube (Valve)
SWR installs a specially selected 12AX7A dual triode on the preamp circuitboard of every 750x. If this
tube needs replacing, we recommend that you replace it with a similar high quality product. This tube will
need replacing if it becomes noisy or microphonic (which sounds like glass tinkling in the background of
certain notes), or completely fails (causing no signal or signal at very low levels). The tube in your 750x
should last one to three years, depending on usage.
RACK MOUNTING INSTRUCTIONS
To preserve the beauty and reliability of your amplifier, we recommend that you install your amplifier in a
16 • 750x OWNER'S MANUAL
Advertisement
