Preparing The Device For Operation - Frigidaire FRS093LW1 Installation Manual

Preparing the device for operation

1. Contact a specialist to install the device.
2. Guarantee that the unit is appropriately fastened and complies with all of
the aforementioned safety norms.
3. Before operating the air conditioner, ensure that the air filter is installed
correctly.
4. If the unit has been out of use for a long period of time, it is recommended
that the air filter be cleaned before use. During continuous use, clean the air
filter every two weeks.
5. This air conditioner was designed for use under the following conditions:
Temperature
Indoor
63°F~90°F
only for models with heating function
*
Attention
If air conditioner is used outside of the above conditions, certain safety protection
features may come into operation and cause the unit to function abnormally.
Room relative humidity should be less than 80%. If the air conditioner operates in
excess of this figure, the surface of the air conditioner may attract condensation.
Please set the horizontal louver to its maximum angle (vertically to the floor), and
set HIGH fan mode.
Optimum performance will be achieved within these operating temperature.
Preparing the device for operation
29
Cool
Outdoor Indoor
64°F~109°F 63°F~86°F
MODE
Heat *
Temperature
Outdoor
19°F~75°F
Dehumidifier
Temperature
Indoor Outdoor
63°F~90°F 52°F~109°F