Procedure 5 - Electronics; Preparing Mkiv Joystick For Use; Repositioning Mkiv Joystick - Invacare Power 9000 Service Manual

PROCEDURE 5
This Procedure Includes the Following:

Preparing MKIV Joystick for Use

Repositioning MKIV Joystick

E
L
E
C
After ANY adjustments, repair or service
T
and BEFORE use, make sure all attaching
R
hardware is tightened securely - otherwise
O
injury or damage may result.
N
I
PREPARING MKIV JOYSTICK FOR
C
S USE (FIGURE 1)
NOTE: To reposition the MKIV joystick on a Captain's Seat,
refer to REPOSITIONING MKIV JOYSTICK - CAPTAIN'S
SEAT in PROCEDURE 8 of this manual.
NOTE: The MKIV joystick is factory installed on the right
side of the wheelchair. To reposition the MKIV joystick onto
the left side of the wheelchair, refer to REPOSITIONING
MKIV JOYSTICK in this procedure of the manual.
1. Turn the lever on the adjustment lock to release the
adjustment lock from joystick mounting tube.
2. Slide joystick mounting tube to the desired position.
3. Turn the lever on the adjustment lock to secure the
adjustment lock to the joystick mounting tube.
Joystick
Mounting Tube
FIGURE 1 - PREPARING MKIV JOYSTICK
WARNING
MKIV Joystick
Adjustment
Lock
Lever
FOR USE
REPOSITIONING MKIV JOYSTICK
(FIGURE 2)
1. Turn the lever on the adjustment lock to release the
adjustment lock from joystick mounting tube (tube).
2. Remove the joystick from the wheelchair.
3. Remove the three (3) hex screws that secure joystick
mounting bracket (bracket), the threaded hole half
clamp and the opened hole half clamp to the arm tube.
4. Reposition the threaded hole half clamp and opened
hole half clamp on the opposite arm tube. Make sure
threaded hole half clamp is on the inside of arm tube.
5. While holding the two (2) half clamps, install the front
hex screw into the two (2) half clamps. Securely tighten.
6. Line up mounting holes of the joystick mounting bracket
with the mounting holes in the two (2) half clamps.
7. Secure the joystick mounting bracket to the two (2)
half clamps with the remaining two (2) hex screws.
8. Slide tube through the bracket to the desired position.
9. Slide the adjustment lock over the end of the tube and
secure the adjustment lock to the tube by turning the
lever on the adjustment lock.
Threaded Hole
Half Clamp
Arm Tube
Adjustment Lock
Lever
Opened Hole Half Clamp
FIGURE 2 - REPOSITIONING MKIV
JOYSTICK
12
ELECTRONICS
Joystick
Joystick Mounting
Tube
Hex Screws
Joystick Mounting Bracket