Advertisement
1
SWING SPOUT ASSEMBLY
Turn off hot and cold water
CAUTION
supplies before beginning.
Assemble the SPOUT
(3)
SPOUT NUT
until snug on VALVE BODY.
(4)
2
FITTING INSTALLATION
Remove LOCKNUT
(1)
GASKET
from fitting.
(3)
Place RUBBER RING
(4)
Insert inlet hoses (on model 7190.132 only) and
THREADED SHANK through hole of sink making
certain RUBBER RING
recess of the fitting base.
Assemble GASKET
(3)
LOCKNUT
onto the THREADED SHANK from
(1)
underside of sink deck.
Tighten the LOCKNUT
For Model 7190.132 Only
Connect the hot water supply to the left inlet hose
and the cold water supply to the right inlet hose
using appropriate connectors.
For Model 7100.2XX Only
Connect hot or cold water supply lines to shank using
sealant, appropriate connectors, and coupling nuts.
3
TEST INSTALLED FAUCET
Remove AERATOR.
With handle in OFF position, turn on water supplies
and check all connections for leaks.
4
SERVICE
To change direction of handle rotation,
proceed as follows:
Turn valve to OFF position.
Remove INSERT and HANDLE SCREW.
Slip HANDLE with ADAPTER off.
Remove SPRING CLIP (1).
Lift STOP WASHER (2), turn 90° and replace.
Replace SPRING CLIP (1).
Replace ADAPTER, HANDLE, SCREW, and INSERT.
5
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
and tighten the
, BRASS WASHER
, and
(2)
in recess of fitting.
is properly seated in the
(4)
, BRASS WASHER
, and
(2)
securely.
(1)
2
90°
MODEL
7190.132
RECESS
HOT
FLEXIBLE
INLET HOSES
Operate both handles to flush water lines thoroughly.
Checkspout mounting and hose connections for leaks.
Turn handles into OFF position and replace AERATOR.
AERATOR may accumulate dirt causing distorted and reduced
water flow. Remove AERATOR and rinse clean.
If spout drips, operate handles several times from OFF to ON
position. Do not force - handles turn only 90°.
1
Plastic SCREEN (3) in CARTRIDGE (4) may accumulate
dirt causing reduced water flow. To clean, first turn
off hot and cold water supplies, then:
Remove INSERT and HANDLE SCREW.
Slip HANDLE with ADAPTER off.
Unscrew CARTRIDGE (4) with wrench.
Thoroughly rinse plastic SCREEN (3) at
base of CARTRIDGE (4).
Replace CARTRIDGE (4) until flange is
tight against valve body.
Turn valves OFF.
Replace ADAPTER, HANDLE, SCREW,
and INSERT.
3
1
MODEL
7100. 2XX
RECESS
4
SHANK
3
2
1
SUPPLY
COLD
NUT
4
3
3 4 4 4 0 R E V. 1. 4
4
2
Advertisement
