Adding A New Drum To A Step; Erase A Drum Sound From A Step; Change A Drum Sound's Volume In A Given Step; Exit Step Edit Mode - Alesis Performance Pad Pro Reference Manual

First, you will need to make sure that you are in Pattern Mode (PATTERN should be displayed in
the upper right corner of the screen). To enter Pattern Step Edit Mode, press the STEP EDIT
button.
BEAT SUB-BEAT PAD NUMBER
The display now shows the beat and sub-beat. If
a drum event exists on this beat/sub-beat, the
display will also show the drum pad that played
the event and the event volume. If more than
one drum event occurs on the same sub-beat,
the PAGE UP/DOWN buttons step forward or
backward respectively through each drum one
at a time.
If no drum event exists on this beat/sub-beat,
the display will show no pad number, and
EMPTY in place of volume data.
EVENT VOLUME
To navigate through the steps at the current quantization rate, use the PAGE UP button to move
forward or PAGE DOWN to move backward. If a drum exists between those beats that fall on the
current quantization value, the drum will sound as you go past it, but the display will not stop on
that drum. If swing is on, step mode will step in "swinged" increments.

ADDING A NEW DRUM TO A STEP

While in Pattern Step Edit Mode, use the PAGE buttons to select the step where the drum is to be
added. Press the pad that corresponds to the sound you want to add. That drum, along with its
volume (how hard the pad was hit), will be recorded into the displayed step.
If you play a pad and there is already a drum event played by that pad on the displayed step, you
will edit the volume rather than add another event. This is true even if there are several events on
the displayed beat, and an event other than the one to be edited is showing.

ERASE A DRUM SOUND FROM A STEP

While in Pattern Step Edit Mode, use the PAGE buttons to locate the step containing the drum to
be erased. While holding down the ERASE button, press REC (ENTER). The drum that was
being displayed will be erased.

CHANGE A DRUM SOUND'S VOLUME IN A GIVEN STEP

Use the PAGE buttons to select the step containing the drum whose volume needs to be
changed. Either press a number button from 1-8 (1=softest, 8=loudest), use the INC / DEC
buttons or VALUE dial, or tap the displayed drum pad at the desired level. If you play a pad to
change the level and there are several events on the same step, the display need not show the
specific drum whose volume you want to edit.

EXIT STEP EDIT MODE

To exit step mode, press STOP, RECORD SETUP, or PLAY (the latter will begin playing the
Pattern from the beginning).
31