Torque Specifications - Husqvarna CTH-180 (V) Operator's Manual

Hide thumbs

Table Of Contents

Table of Contents

6 Re-tighten the two hex nuts on the cog idler pulley

and the belt is now adjusted correctly.

7. To re-install the cutting pan - reverse the procedure.

Note: It is possible but not desirable to adjust the cog

belt tension without removing the cutting pan assembly

form the tractor. In this case follow step 2 through 8

from the above procedures.

DANGER

This cog belt must be properly adjusted. If not, the

blades can contact and the belt will be destroyed and

the cutting system will be damaged.

Fig. 33

DANGER

On impact with any hard objects, the blade shear bolts

will break and the cog belt will be damaged!

The cog belt must be inspected.

Be careful!

The two blades must be positioned 90 degrees to each

other.

Replacement:

Use always genuine parts.

Fig. 34

– English

ADJUSTMENTS

ADJUSTMENT PROCEDURES FOR THE

HEIGHT ADJUSTMENT CABLE ASSY

1. Place the tractor on a flat surface, concrete, if

possible.

2. Move the lower pin of the front adjustment suspen-

sion into the bottom position of the slotted holes by

adjusting the two nuts M12 on the front suspension.

3. Using the height adjustment lever, lift the cutting pan

to the mid-position.

4. Insert a 6 mm thick board under the rear cutting pan

gauge wheels.

5. Let the cutting pan down until the rear gauge wheels

rest on the board.

6. Position the height adjustment lever to position 1.

7. Keep adjustment self-locking nut 5/16-18 at the end

of the height adjustment cable assyuntil the cable is

slightly tight only.

8. Lift the cutting pan and take out the board.