Lenovo 10B4 User Manual page 64

3. Position the solid-state drive into the storage converter so that the holes in the drive are aligned with
the corresponding holes in the converter. Then, install the four screws to secure the solid-state drive
to the converter.
Figure 26. Installing the solid-state drive into the storage converter
Replacing the solid-state drive on the bottom of the optical drive bay
To replace the solid-state drive on the bottom of the optical drive bay, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 40.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 40.
4. Pivot the drive bay assembly upward. See "Accessing the system board components and drives"
on page 42.
5. Disconnect the signal cable and the power cable from the solid-state drive.
52
ThinkCentre M73 User Guide