Cisco WAP4410N User Manual page 21

• IP Address—The IP address must be unique to your network. The default IP address is
192.168.1.245.
• Subnet Mask—The Subnet Mask must be the same as that set on the LAN that your
Access Point is connected to. The default is 255.255.255.0.
Select Automatic Configuration if you have a DHCP server enabled on the LAN that can assign
an IP address to the Access Point.
IP Settings (v6)
Enabled/Disabled. Enabled or Disabled IPv6 settings. The default is Disabled.
Select Static IP Address (default) if you want to assign a static or fixed IP address to the Access
Point. Then complete the following:
• Local IP Address—The IP address must be unique to your network.
• Prefix Length—Enter the Prefix length to match the IP address above.
• Default Gateway—Enter the IP Address of your Gateway or Router. Enter the value
used by other devices on your LAN.
Select Automatic Configuration if you have an IPv6 RADVD device enabled on the LAN that
can assign an IP address to the Access Point.
Change these settings as described here and click Save Settings to apply your changes, or click
Cancel Changes to cancel your changes. Help information is displayed on the right-hand side
of the screen.
WAP4410N User Guide
Configuring the Wireless-N Access Point
The Setup - Basic Setup Tab
16