Setting The Virtual Display; Enable The Virtual Display Driver (Windows Only); Adjusting The Virtual Display - Epson EasyMP Network Projection Operation Manual

Using Multi-Screen Display
Open the file to be projected, and then move the screen to the virtual display
according to the actual projection arrangement.
3. Projecting the allocated images s
Allocate a virtual display number to a projector that is connected through the
network, and then start projection.

Setting the Virtual Display

This chapter explains the virtual display for arrangement example 1.
p.21
s

Enable the virtual display driver (Windows only)

Enable the virtual display g driver. Those users listed below do not have to
perform this operation. Go to procedure
p.22.
• Those users who have enabled virtual displays installing EasyMP
Network Projection.
• For Mac OS users.
Procedure
A
Start Windows on the computer, and then select "Start" -
"Programs" (or "All Programs") - "EPSON Projector" - "EasyMP
Network Projection" - "Add-Remove Virtual Display".
The Add-Remove Virtual Display screen is displayed.
B
Select the virtual display you want to use.
Up to four monitors can be added. In this example, a single virtual
display is to be used. When setting multiple virtual displays, select as
many displays as is necessary.
Any one of the displays can be selected.
p.26

"Adjusting the Virtual Display"

s
C
Click "OK".
When you click OK, the drivers for the virtual display are enabled. At
this point, it is normal for the display to flicker. Wait for the Add-
Remove Virtual Display screen to close.
Adjusting the Virtual Display
After starting EasyMP Network Projection, the procedure for setting up the
virtual displays differs for Windows and Mac OS. The procedures are
explained separately below.
Check the following points before starting EasyMP Network Projection
q
when connecting via Wireless LAN. If the following points are not set
correctly, Multi-screen display cannot be used.
• The SSID for the computer and each projector must be the same.
• The wireless LAN system for the computer and each projector must
be the same.
You can modify the SSID and Wireless LAN system for the
projector from the Network menu in the projector's Configuration
menu. s User's Guide "Wireless LAN Menu"
22