Epson EasyMP Network Projection Operation Manual page 14

Connecting to a Projector on a Network and Projecting
When the system starts in Quick Connection Mode.
A
Automatic search
In Advanced Connection Mode, you can search for available projectors
on the network system to which the computer is connected.
In Quick Connection Mode, you can search for the projector based on
the SSID.
B
Manual search
In Advanced Connection Mode, you can search for a projector based on
a specified IP address or projector name.
In Quick Connection Mode, you can search for the projector based on
the SSID selected from a list.
C
Status
The following six icons indicate the status of the detected projectors.
Standby
Busy
Select for connecting.
Select for connecting. When you click
Connect, the computer currently
connected is disconnected and your
computer is connected.
Busy (Disable
interrupt con‐
nection)
Currently in
use by another
application
Searching
Not found.
D
Projector name
The projector's name is displayed.
E
Disable interrupt connection
Check the box to prevent an interrupt connection by other computers while
connected to the selected projector.
F
Use multi-display
Check the box to use the Multi-screen display function. When this is selected,
Display layout and Display properties are displayed at the bottom of the screen.
p.20
s
G
Troubleshooting
If there is a problem and you cannot have a connection, press this button to open
the EasyMP Network Projection Troubleshooting screen.
H
Connect
Connect to the projector you selected from the search results list. When a
connection is made with a projector, a toolbar is displayed.
I
Set options
You can make general setting options such as the processing method when
starting up EasyMP Network Projection. For details, see Set options. s
J
Save in the profile
Saves the results of a network projector search as a Profile. s
Cannot be selected. Disable interrupt
connection is set on another computer
which is already connected.
The projector's Configuration Menu is
open. You can select it after closing the
Configuration menu and running the
search again.
Displayed while running Manual search or
Profile.
Displayed when a projector cannot be found
as a result of Manual search or Profile. In
Quick Connection Mode, you can only
select multiple projectors with the same
SSID.
p.34
p.30
14