Detailed Physical Description - On-Q 364772-01 User Manual

D. On-Q Home 4 Port Router/Switch Detailed Physical Description
The following information describes the physical characteristics of the
On-Q Home Router/Switch:
1. Router/Switch Module Connection Area
Figure 2 shows the Router/Switch connection area including:
DC Input connector – connection from power supply
WAN (Internet) Port – 8 position RJ-45 jack (connects to Cable or
DSL modem)
Local Switch Ports – 8 position RJ-45 jacks (connection from outlets
in rooms)
Reset Button - A button press (over 3 seconds) resets the
Router/Switch unit to the factory default settings. This clears all user
settings, including User Name, Password, IP Address, and Subnet
Mask.
NOTE: Refer to Section IV Configuration for instructions on re-
configuring the Router/Switch.
Diag LED WAN LEDs
Power LED
DC Input
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Innovations in Home Living.
(800) 321-2343
(
Page 3
Switch Port LEDs
WAN Port Local Switch Ports
Reset Button
Figure 2
©Copyright 2004 by OnQ Technologies,
Inc All Rights Reserved.
www.onqhome.com
) 4
2. Router/Switch Status LEDs (see Figure 2)
STATUS
Innovations in Home Living.
Power – On solid orange when power is supplied.
Diag – On solid green indicates router's self-diagnosis mode is
running during boot-up/restart.
10/100 Local Port and WAN Port LEDs
Link/Act – On solid green indicates functional network link
through the port with the attached device. Blinking green
indicates router is sending/receiving data over that port.
Fdx/Col – On solid green indicates the connection through the
port is running in Full Duplex Mode. Blinking green indicates
connection is experiencing collisions.
100/10 – On solid orange indicates port is operating at 100
Mbps. Off indicates 10 Mbps.
301 Fulling Mill Road, Suite G
Middletown, PA 17057
(800) 321-2343
( ) 4
Page 4
©Copyright 2004 by OnQ Technologies,
Inc All Rights Reserved.
www.onqhome.com