Jacuzzi J - LX Owner's Manual page 23

14. Turn on jet pumps when adding chemicals to ensure proper mixing
and leave your hot tub cover open until the sanitizer level becomes
stable to protect pillows and plastic knobs from chemical attack.
Refer to the inside cover of the manual.
WARNING:
!
• To decrease the risk of injury, entrapment or drowning,
never leave your hot tub unattended for any reason, es-
pecially if while the cover is open and accessible to small
children and animals!
• To decrease the risk of contracting a waterborne illness
(e.g. an infection, bacteria or virus) and/or respiratory
ailments, maintain water chemistry within 6 step param-
eters. If you or other bathers experience such a condition,
discontinue use and seek immediate medical attention.
15. Establish a sanitizer reading no less than 1.0 ppm free chlorine
or 2.0 ppm bromine, then allow the hot tub to set undisturbed for
8 hours. Retest water after 8 hours to determine if sanitizer levels
are stable. If sanitizer levels are stable, your spa is ready for use.
To ensure healthy water conditions, always maintain a constant
sanitizer reading within the levels recommended on the inside cover
of this manual. If sanitizer levels are not stable at this time, it will be
necessary to repeat this procedure in its entirety (steps 1-15) until
stable sanitizer readings are achieved.
IMPORTANT: If the CLEARRAY® water purification system is removed
from the hot tub or is not operating effectively follow the "without
CLEARRAY®" water chemistry parameters as defined by the Association
of Pool and Spa Professionals.
16. After adequate sanitizer levels are achieved, close all spa air controls
to maximize heat retention when spa is not in use.
RISK OF PERSONAL INJURY.
LX Collection
19