Bunn H5E Installation & Operating Manual page 13

PROGRAMMING - H5-ELEMENT Continued
LEVEL 2 PROGRAMMING
H2 - F° OR C° SELECTION
1. To enter Level 2 Programming, press and hold the upper hidden button until H2
appears on the display. Release the upper hidden button. The display will show
either FAH (Degrees in Fahrenheit) or CEn (Degrees in Centigrade).
2. Press and release the (+) or (-) buttons to alternate between FAH and CEn.
3. After setting FAH or CEn, to exit Level 2 Programming, press and release the upper
hidden button twice. Display will show, software version, then main screen.
H3 - RESTORING FACTORY DEFAULTS
1. To restore Factory Defaults (This clears all settings that were previously entered),
press and release the upper hidden button until H2 appears on the display (ap-
proximately 6 seconds). Release the upper hidden Button, then press and release
the upper hidden Button once more. The display will read H3, then show (- - -).
2. Press and hold both (+) and (-) buttons to initiate the resetting of the factory
default settings. The display (- - -) will flash on and off during this time.
3. When the factory default numbers are loaded in, the display will stop flashing,
then read don (DONE). You can now release the two buttons.
NOTE: If you release the two buttons at any time before the display reads don, the Fac-
tory Default numbers will not be entered. The old numbers will remain in the memory.
13
46819 043012