Setting The Event - Samsung SRN-470D User Manual

SETTING THE EVENT

You can set recording options for sensor, motion, and video loss event.
Sensor Detection
You can set the sensor's operating condition and connected camera, as well as alarm output and its duration.
[MENU]  ▼  <Event>  ►▼  <Sensor Detection>  [ENTER]  ▲▼◄►  [ENTER]
• Sensor Operation : Sets the operation mode of sensors.
- <OFF> : Sensor does not operate.
- <N.O (Normal Open)> : Sensor is opened. If the sensor is closed, it generates alarm.
- <N.C (Normal Close)> : Sensor is closed. If the sensor is open, it generates alarm.
• Cam : Select a channel to be connected to the sensor.
If selected camera, "Cam Preset setup" window appears.
Select a channel and setup the preset.
`
Preset setup can be done in PTZ mode.
• Alarm out : Sets the alarm output method.
`
For further information on alarm output, refer to "HDD Alarm > Alarm". (Page 57)
`
SRN-470D supports only alarms <1> and <2>.
• Duration : Sets the duration of alarm signal and alarm sound.
M
`
If you select <Network Camera> tab, you can configure the sensor operation settings of the network camera connected to
each channel.
`
If the connected network camera that has configured the alarm in/out settings triggers an alarm, NVR will perform the alarm out.
English _65