General Control; Setting The Clock (Remote Control Only) - Sharp XL-DAB151PH(S) Operation Manual

General control

CD/USB
RDS
DAB
■ To turn the power on
Press the ON/STAND-BY button to turn the power on.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
■ Display brightness control
To dim the display brightness, press the DEMO/DIMMER button on
the remote control.
Dimmer 1
Dimmer 2
Dimmer off
■ Volume auto set-in
If you turn off and on the main unit with the volume set to 17 or higher,
the volume starts at 16.
■ Volume control
Turn the volume knob towards VOLUME +/– (on main unit) or press
VOL +/– (on remote control) to increase or decrease the volume.
■ Auto power on function
When you press any of the following buttons, the unit turns on.
● iPod, CD, USB, AUDIO / LINE (INPUT), TUNER/DAB on the
remote control: Selected function is activated.
●
/ button on the main unit: The unit turns on and playback of
the last function will start (CD, TUNER/DAB, USB, iPod, AUDIO
IN, LINE IN)
■ Auto power off function
The main unit will enter the stand-by mode (when iPod or iPhone is
not docked) after 15 minutes of inactivity during:
iPod: No connection.
AUDIO IN / LINE IN: No detection of input signal or very low sound
audibility.
CD / USB: In the stop mode.
Note:
However, if iPod or iPhone is docked, the unit will begin charging.
"Charge Mode" will be displayed during standby mode.
■ Muting
The volume is muted temporarily when pressing the MUTE button on
the remote control. Press again to restore the volume.
■ X-Bass control
When the power is first turned on, the unit will enter the extra bass
mode which emphasises the bass frequencies, and "X-BASS" will
appear. To cancel the extra bass mode, press the X-BASS button on
the remote control.
(Display is dim).
(Display gets dimmer).
(Display is bright).
■ Bass control
1
Press the BASS/TREBLE button to select "Bass".
2
Within 5 seconds, press the VOLUME (+ or –) button to adjust the
bass.
■ Treble control
1
Press the BASS/TREBLE button to select "Treble".
2
Within 5 seconds, press the VOLUME (+ or –) button to adjust the
treble.
■ Function
When the FUNCTION button on main unit is pressed, the current
function will change to different mode. Press the FUNCTION button
repeatedly to select desired function.
FM STEREO
CD
Line In Audio In
Note:
The backup function will protect the memorised function mode for a
few hours should there be a power failure or the AC power lead
becomes disconnected.

Setting the clock (Remote control only)

In this example, the clock is set for the 24-hour (00:00) display.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK/TIMER button.
3
Within 10 seconds, press the ENTER button. To adjust the day,
press the or
button.
4
Press the or
display and then press the ENTER button.
The 24-hour display will appear.
(00:00 - 23:59)
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
8
- 5 ↔ - 4 ........ ↔ + 4 ↔ + 5
- 5 ↔ - 4 ........ ↔ + 4 ↔ + 5
FM MONO
USB
iPod
CD/USB
RDS
DAB
button and then press the ENTER
button to select 24-hour or 12-hour
DAB