Selection Of Installation Place - Haier HBU-42CH03 Operation & Installation Manual

Installation Procedure
Before installation
1
Determine the way to carry unit to installation place.
Don't remove packing until unit reaches installation place.
If unpacking is unavoidable, protect unit properly.

Selection of installation place

2
(1) Installation place shall meet the following and agreed by customers:
Place where proper air flow can be ensured.
No block to air flow.
Water drainage is smooth.
Place strong enough to support unit .
Place where inclination is not evident on ceiling.
Enough space for maintenance.
Indoor and outdoor unit piping length is within limit. (Refer to Installation Manual for outdoor
unit.)
Indoor and outdoor unit, power cable, inter unit cable are at least 1 m away fromT.V. radio.
This is helpful to avoid picture disturbance and noise. (Even if 1 m is kept, noise can still appear
if radio wave is strong)
(2) Ceiling height
Indoor unit can be installed on ceiling of 2.5-3m in height. (Refer to Field setting and Installation
Manual of ornament panel.)
(3) Install suspending bolt. Check if the installation place is strong enough to hold weight. Take
necessary measures in case it is not safe. (Distance between holes are marked on paper pattern.
Refer to paper pattern for place which need be reinforced)
Unit:mm
Air outlet
1500 Over
Model
HBU-36HH03 HBU-42CH03
HBU-42CI03 HBU-42HI03
HBU-48CH03
<Don't discard any accessories until completed>
Installation space
Air outlet
Air inlet
1500 Over
H
310
Air outlet
1500 Over
Model
HBU-28CH03 HBU-28HH03
HBU-48HJ03 HBU-48CK03
16
Air outlet
Air inlet
1500 Over
H
260
290