21
cleaning the tray
1. Firstly, open the front door where
2. Then, to remove the ice-tray from its
3. To replace the ice-tray in the Smart
4. Afterwards, push the tray by the
5. Close the lid of the Smart Fill Ice
important:
regular use of the Smart Fill Ice Factory. This residue could form on the
lid you use to fill the water cylinder, the cylinder valve, and the ice-box,
thus affecting the working of different parts of the system.
Don't use ice-picks, forks, or knives to remove the residual ice as to do
so could damage the Smart Fill Ice Factory.
you see a small lip on the right-hand
side. Pull the door towards you until
completely open.
fitting, take it by the right-hand side
and at the same time, pull it down
and towards you. Finally, pull it out by
the centre, keeping it horizontal.
Fill Ice Factory, align the short sides
with the lateral fittings and push it
until it's completely inserted.
right-hand side until you hear a click,
which will ensure the tray securely in
place while working.
Factory. Your device will be ready for
use once again.
Use tepid water to remove residual ice which will form with
Need help?
Do you have a question about the ingenious and is the answer not in the manual?