Key To Symbols; Symbols On The Machine; Symbols In The Operator's Manual - Husqvarna 365 X-torq Operator's Manual

Symbols on the machine:

WARNING! Chain saws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you understand
the instructions before using the
machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Chain brake, activated (right)
Chain brake, not activated
(left)
Both of the operator ' s hands must be
used to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
Contact of the guide bar tip with any
object must be avoided.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May
cause serious personal injury.
Recommended cutting
equipment in this
example:
- Bar length 18 inches
- Max. nose radius 11 Teeth
- Chain type Husqvarna H42
Measured maximum kickback value with
brake for the bar and chain combination on
the label.
Measured maximum kickback value
without triggering the brake, for the bar and
chain combination on the label.
Decompression v alve: The valve is to
reduce the pressure in the cylinder and
make starting easier. You should always
use the decompression valve when
starting the machine.
2 – English

KEY TO SYMBOLS

Ignition; choke: Set the choke control in
the choke position. This should
automatically set the stop switch to the
start position.
Adjustment of the oil pump.
If your machine bears this symbol it is
equipped with heated handles.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.

Symbols in the operator's manual:

Switch off the engine by moving the
stop switch to the STOP position
before carrying out any checks or
maintenance.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.
Refuelling.
Filling with oil and adjusting oil flow.
The chain brake should be activated
when starting.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May
cause serious personal injury.