Myryad MX Series Owner's Manual

Myryad MX Series Owner's Manual

Mx series modular power amplifier

Advertisement

Quick Links

MX SERIES
Modular Power Amplifier
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MX Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Myryad MX Series

  • Page 1 MX SERIES Modular Power Amplifier Owner’s Manual...
  • Page 2: Table Of Contents

    The MX Modular PA may be controlled Your Myryad Power Amplifier is supplied remotely via the My-Link communications complete with the following accessories: bus when used with other Myryad products. My-Link allows remote control of standby • My-Link interconnect (0.5m RCA-RCA) and mute functions.
  • Page 3: Power Inlet

    MX power amplifier to the MY-LINK IN switch is turned OFF before making or Before making any connection, check that socket on a third Myryad component (if changing any connections to the amplifier. the mains voltage setting printed on the desired) and so on –...
  • Page 4: Line Input

    "-" terminal on the fitted or exchanged by qualified service loudspeaker. The red (+) terminal on the personnel. Consult your Myryad dealer for amplifier should be wired to the red or "+" details terminal on the loudspeaker.
  • Page 5: Loudspeaker Output

    USING YOUR MXA FRONT PANEL CONTROLS 1. Standby Please note: When the power amplifier is then it will take some time for the module’s When the amplifier is plugged into a live remotely activated from another unit, there heatsink to cool sufficiently to allow the wall socket and the POWER switch is may be a time difference between the loudspeaker to be re-connected (probably...
  • Page 6: Fault Condition Indication

    Hence: With 2x80W modules, the upper amplifier channel in each module has the same FAULT CONDITION number as the module (1 to 7), but the Module 1 reporting lower amplifier has that number plus 7, so INDICATION fault the lower amplifier channels run from 8 to Module 2 reporting 14 (8 being the lower channel of the far left fault...
  • Page 7: Trouble-Shooting Guide

    Protection relay has operated because Amplifier fails to respond to Smart My • of a short circuit loudspeaker wire or Link® remote commands from Myryad Power turned off or system in standby • amplifier overheating (see Fault Preamplifier, Preamp-Processor or mode.
  • Page 8 Stortford Hall Industrial Park, Dunmow Road Bishops Stortford, Hertfordshire, CM23 5GZ United Kingdom www.myryad.co.uk www.armourhe.co.uk Stock No: 0ST0012310 C...

This manual is also suitable for:

Mxa0151Mxa0152Mxa0153Mxa0154Mxa0155Mxa0156 ... Show all

Table of Contents