Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Myryad Z Series
Summary of Contents for Myryad Z Series
- Page 1 Z - S e r i e s Z 3 5 0 I n te gr a te d A m p l i f i e r Owner’s manual www.myryad.co.uk...
- Page 2 • Specifications INTRODUCTION INSTALLATION AND SAFETY The Myryad Z350 Integrated Amplifiers have been designed to deliver The Z350 generates a modest amount of heat and requires ventilation. a combination of high quality sound reproduction and elegant styling. Do not place it on a rug or other soft surface into which it could sink, obstructing the air inlets in its underside.
- Page 3 SETTING UP YOUR AMPLIFIER RIGHT SPEAKERS LEFT www.myryad.co.uk BT ANT DESIGNED IN ENGLAND BY MYRYAD SYSTEMS LTD MADE IN CHINA POWER SACD TAPE BYPASS PER OUT MINIMUM SPEAKER IMPEDANCE 4 USB DAC OPTICAL COAXIAL MINIMUM IMPEDANCE DES HAUT PARLEURS 4...
- Page 4 During this delay period the The volume control adjusts the sound level for both loudspeakers (via LED on turns blue in the display and the display will indicate “MYRYAD”. the amplifier outputs). When the STANDBY ellipse is touched (3 second) again the amplifier will be returned to standby mode.
- Page 5 REMOTE CONTROL MUTE DIMMER Mute on integrated amplifier MUTE DIMMER Screen On/Off TUNING Scan back Random play Scan forward PRESET FREQ Skip back to previous chapter Repeat Chapter/Title/Disc Skip forward to next chapter BAND ENTER Stop Play/Pause MENU Navigate and select from Confirms/Selects item.
- Page 6 LOUDSPEAKER OUTPUT PROTECTION AND MUTING When the amplifier is in standby mode the loudspeaker output amplifier overheating, amplifier DC fault) the loudspeakers will be terminals are isolated from the amplifier by high quality relays. When disconnected from the amplifier to protect both. In the case of a short the amplifier is first switched on from standby mode the loudspeaker circuit or DC fault the loudspeakers will be re-connected after a few outputs remain disconnected for a few seconds to allow the internal...
- Page 7 INSTALLING AND REPLACING BATTERIES The remote handset uses two 1.5 V type AAA batteries. To fit new The batteries should always be removed if they are discharged batteries first open the battery compartment at the base of the (indicated by no remote control operation or by operation only at very handset and remove any existing batteries.
- Page 8 Myryad Systems Ltd. Our policy is one of continuous product improvement, we reserve the right to change the designs and specifications without notice. All information is given in good faith. The manufacturer accepts no responsibility for errors, omissions or incorrect assumptions.
Need help?
Do you have a question about the Z Series and is the answer not in the manual?
Questions and answers