Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Myryad MXP2000
Summary of Contents for Myryad MXP2000
- Page 1 MXP2000 Remote Controlled Stereo Preamplifier Owner’s Manual...
- Page 2 • Accessories Do not place it on a rug or other soft surface into which it could sink, obstructing the air The MXP2000 can accept up to eight line- level input sources, including two tape inlets in its underside. The preamplifier •...
- Page 3 OFF. When the POWER switch is in the Each of these pairs of line outputs is OFF position all power is disconnected designed to feed the line inputs of a Myryad 6. CD-R input/output from the amplifier. In this condition the...
- Page 4 STANDBY and re-instated when it is only a small part of the internal circuitry of switched on again. However, if the unit is the MXP2000 is powered up, so it The infra-red (IR) remote control receiver is switched to STANDBY with a volume setting...
- Page 5 CD or DVD source as necessary. as the STANDBY ellipse on the front panel. It "toggle" function switch: you press it once sends the command to switch the MXP2000, to engage and press again to disengage Intelligent Input Selection (Amplifier)
- Page 6 15 seconds the MXP2000 will drop out of menu mode automatically. Input level trims The MXP2000 is supplied with all of its All the settings programmed using the inputs set to nominal sensitivity (see menu system are stored in non-volatile specifications).
- Page 7 • TAPE has been selected with no tape without making any change, press MENU, playing. or let the MXP2000 drop out of the menu automatically after a few seconds. SPECIFICATIONS Line Direct, Tape , CD-R, CD, Tuner, TV, DVD, Aux...
- Page 8 Myryad Systems Ltd. 2 Pipers Wood, Waterberry Drive Waterlooville, Hants, PO7 7XU Tel: +44 (0) 23 9226 5508 Fax: +44 (0) 23 9223 1407 tech@myryad.co.uk www.myryad.co.uk For further information, Please contact Myryad direct or visit: www.myryad.co.uk Part Number: 0ST0012430 A...
Need help?
Do you have a question about the MXP2000 and is the answer not in the manual?
Questions and answers