Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Myryad MXA0151
Summary of Contents for Myryad MXA0151
- Page 1 MX SERIES Modular Power Amplifier Owner’s Manual...
-
Page 2: Table Of Contents
The MX Modular PA may be controlled complete with the following accessories: remotely via the My-Link communications bus when used with other Myryad products. My-Link interconnect (0.5m RCA-RCA) My-Link allows remote control of standby Separate mains power cord to suit and mute functions. -
Page 3: Power Inlet
MX power amplifier to the MY-LINK IN 1. Power Inlet IMPORTANT: Make sure the POWER socket on a third Myryad component (if switch is turned OFF before making or Before making any connection, check that desired) and so on – in “daisy-chain”... -
Page 4: Rear Panel Diagrams
1. Line input The line input can be driven from the line outputs of any good quality processor or preamplifier (such as the Myryad MXD6000 or MXP2000) or any other suitable line level source. High quality RCA-to-RCA (phono- to-phono) interconnects should be used. -
Page 5: Front Panel Controls
USING YOUR MXA FRONT PANEL CONTROLS then all seven LEDs will light blue. then it will take some time for the module’s heatsink to cool sufficiently to allow the 1. Standby Please note: When the power amplifier is loudspeaker to be re-connected (probably remotely activated from another unit, there between ten and twenty minutes depending When the amplifier is plugged into a live... -
Page 6: Fault Condition Indication
Hence: With 2x80W modules, the upper amplifier channel in each module has the same FAULT CONDITION number as the module (1 to 7), but the npppppp Module 1 reporting lower amplifier has that number plus 7, so INDICATION fault the lower amplifier channels run from 8 to pnppppp Module 2 reporting 14 (8 being the lower channel of the far left... -
Page 7: Trouble-Shooting Guide
No sound from one channel only: Amplifier fails to respond to Smart My Loudspeaker cable pulled loose. Check all Link® remote commands from Myryad TROUBLE- connections, both at the loudspeakers and Preamplifier, Preamp-Processor or amplifier. Integrated: SHOOTING GUIDE – Interconnect cable pulled loose or My-Link cable is loose or not making poor contact. - Page 8 Myryad Systems Ltd. 2 Pipers Wood, Waterberry Drive Waterlooville, Hants, PO7 7XU Tel: +44 (0) 23 9226 5508 Fax: +44 (0) 23 9223 1407 info@myryad.co.uk www.myryad.co.uk For further information, Please contact Myryad direct or visit: www.myryad.co.uk Stock No: 0ST0012310 B...
Need help?
Do you have a question about the MXA0151 and is the answer not in the manual?
Questions and answers