Wipers And Washers - Honda CR-V Owner's Manual

Wipers and Washers

■
Windshield Wipers/Washers
Pull to
use
washer.
Intermittent Time
Adjustment Ring *
MIST
OFF
INT: Low speed with
intermittent
LO: Low speed wipe
HI: High speed wipe
* Not available on all models
uuOperating the Switches Around the Steering WheeluWipers and Washers
The windshield wipers and washers can be
used when the ignition switch is in ON
■
MIST
The wipers run at high speed until you release
the lever.
■
Wiper switch (OFF, INT, LO, HI)
Change the wiper switch setting according to
the amount of rain.
■
Adjusting the delay *
Turn the adjustment ring to adjust the wiper
delay.
Long delay
Short delay
■
Washer
Sprays while you pull the lever toward you.
When you release the lever, the wipers make
two or three more sweeps before stopping.
1Wipers and Washers
NOTICE
Do not use the wipers when the windshield is dry.
( w .
The windshield will get scratched, or the rubber
blades will get damaged.
NOTICE
In cold weather, the blades may freeze to the
windshield, becoming stuck.
Operating the wipers in this condition may damage
the wipers. Use the defroster to warm the
windshield, then turn the wipers on.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
Models with intermittent time adjustment ring
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens. When the vehicle starts moving, the
wipers make a single sweep.
When the vehicle speeds up, the wiper operation's
shortest delay setting (
the same.
Continued
) and the LO setting become
115