Motorola DCT6200 Setup Manual page 6

Connecting the DCT6200/DCT6208 to a High-Definition TV – Video Only
TO
TV/VCR
DVI IN R
L
Cable/
Antenna IN
This diagram shows the High-Definition video
connection between your Motorola
DCT6200/DCT6208 and your High-Definition
television (HDTV). This is the primary diagram
for providing HD video and should be done
prior to the following audio configurations.
IR
CABLE
USB
IN
HDTV
Video 1
Video 2 Video 3
Y
S-Video
Pb
Video
Pr
R R R
Audio
L L L
Connector cables to be used:
• 6 ft coaxial cable
• Three-pronged component video cable
1. Using a coaxial cable, connect cable wall outlet to the CABLE IN coaxial input on the cable box.
2. Locate the Y Pb Pr inputs on your HDTV and the Y Pb Pr outputs on the cable box.
To make identification easy, these connecters are color-coded on the cable box
(Y = green, Pb = blue, and Pr = red). Colors may vary on your HDTV.
3. Using a three-jack component video connector, connect the Y output on the cable box
to the Y input on your HDTV. Do the same for the Pb and Pr connections.
DCT5100/DCT6200/DCT6208
AUDIO IN VIDEO
R L SPDIF IN OUT
S-VIDEO
TV
Pass Card
R L
Y Pb Pr
AUDIO
OPTICAL
OUT
SPDIF
IEEE 1394
SWITCHED
105/125V
60Hz
4A MAX
CONVENIENCE
500W MAX
OUTLET
Do not plug the DCT6200/DCT6208 power cord into a
wall outlet until you have completed all connections
between the DCT and other components.