Motorola DCT6200 Setup Manual page 8

Connecting the DCT6200/DCT6208 to a High-Definition TV and VCR
TO
TV/VCR
Cable/
Antenna IN
Cable/
Antenna OUT
DVI IN
Cable/
Antenna IN
1. Using the Video Only diagram, connect your coaxial cable to the Motorola cable box and the cable box Y Pb Pr HD video connection directly
This diagram should be
used if you intend to use
a standard stereo VCR in
your configuration. This
configuration will allow
you to watch both HD
and Standard Definition
2. Connect the single connector end of a Y audio splitter cable to the AUDIO OUT R (red) on the cable box. Insert the other ends into the
video on your HDTV as
well as record and play
3. Use the second splitter cable to connect the AUDIO OUT L (white) on the cable box to the AUDIO IN L connections on both the VCR and the HDTV.
Standard Definition video
4. Use the two-pronged RCA cable to connect the AUDIO OUT L & R on your VCR to the AUDIO IN L & R on your HDTV.
via your VCR.
5. Using an S-video cable, connect the S-VIDEO output on the cable box to the S-VIDEO IN on your VCR. Then use the second
– OR –
6. Using your single-pronged RCA type video connector cable, connect the VIDEO OUT (yellow) connector on the cable box to the
IR
CABLE
USB
IN
Audio IN
Video IN
R L
Audio OUT Video OUT
R L
Video 1 Video 2
R
L S-Video
Video
R R
Audio
L L
to your HDTV.
Connector Cables to be used (not all cables included):
• 1 set of two-pronged RCA type audio cables (red & white)
• 2 S-video cables – OR – 2 sets of single-pronged RCA type video cables (yellow)
Note: The video cables you use will depend on the inputs/outputs on your VCR and HDTV. S-video is considered the higher standard definition video output
and should be your first choice.
AUDIO IN R on your VCR and AUDIO IN R on your HDTV.
S-video cable to connect the S-VIDEO output on the VCR to the S-VIDEO IN on your HDTV.
VIDEO IN connector on your VCR. Next, use the second single-pronged RCA type video connector cable to connect the VIDEO OUT connector
on your VCR to the VIDEO IN connector on your HDTV.
DCT5100/DCT6200/DCT6208
AUDIO IN VIDEO
R L SPDIF IN OUT
S-VIDEO
TV
Pass Card
R L
Y Pb Pr
AUDIO
OUT
VCR
S-Video IN
S-Video OUT
HDTV
Video 3
Y
Pb
Pr
R
L
• 2 sets of "Y" audio splitter cables
IEEE 1394
SWITCHED
105/125V
60Hz
4A MAX
CONVENIENCE
500W MAX
OPTICAL
OUTLET
SPDIF
Do not plug the DCT6200/DCT6208 power cord into a
wall outlet until you have completed all connections
between the DCT and other components.