Honda 2005 CIVIC Installation Instructions Manual page 7

15. Install the 2A fuse into the No.15 slot of the fuse
box.
NOTE: The No. 15 slot with the new 2 amp fuse
controls the memory for the security system. In
some vehicles, you may find a higher amp fuse
already installed in the No. 15 slot. That fuse
serves no purpose for this vehicle; remove it.
No. 15
SLOT
16. Unplug the vehicle 10-pin connector from the fuse
box, and plug the 10-pin connector from the
security system harness into the fuse box. Plug
the vehicle 10-pin connector into the remaining 10-
pin security system harness connector.
SECURITY
SYSTEM
HARNESS
FUSE
BOX
17. Reinstall the fuse box. Be careful not to pinch the
harness.
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
FUSE BOX
FUSE
(2A)
SECURITY SYSTEM
HARNESS
10-PIN CONNECTORS
VEHICLE
10-PIN
CONNECTOR
AII 27876 (0408)
18. Get the upper steering column cover removed in
step 5. Measure and mark the inside of the upper
steering column cover.
CENTER OF THE
UPPER STEERING
COLUMN COVER
19. While wearing eye protection, lightly center-punch
the mark, and drill a 5.5 mm hole through the
center-punched mark. Remove all burrs.
20. Route the terminal ends of the LED through the
hole you just drilled, and secure the LED with the
push nut. Install the push nut securely.
UPPER
STEERING
COLUMN COVER
PUSH
NUT
2-PIN
CONNECTOR
2-PIN
CONNECTOR
RED WIRE
21. Get the 2-pin connector included in the kit. Firmly
push the LED terminals into the 2-pin connector
until they click into position, then lower the lock.
5.5 mm
DRILL
BIT
UPPER STEERING
COLUMN COVER
65 mm
LED
WHITE
WIRE
PUSH
NUT
7 of 10