Models With Touch Pads; Remote Control - GE AS05 Series Owner's Manual & Installation Instructions

About the controls on the air conditioner–models with touch pads.
Features and appearance will vary.
TIMER
HIGH
FAN
MED
LOW
Air Conditioner Controls
Controls
ON/OFF Pad
Turns air conditioner on and off.
Display
Shows the set temperature or time remaining
on timer.
MODE
Use to set the air conditioner to COOL or
FAN mode.
Increase
Use to set temperature when in COOL mode or
to set the time when using the timer feature.
FAN Pad
Use to set the fan speed at LOW, MED or HIGH .
CIRCULAIRE Pad
Turn on to provide continuous side-to-side
air circulation.
For fixed side-to-side air direction, turn ON
until the desired air direction is obtained,
then turn it OFF .

Remote Control

To ensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
The remote control signal has a range of up
to 21 feet.
ENERGY
SAVER
CIRCULAIRE MODE
/Decrease Pads
POWER
COOL
FAN
ENERGY SAVER Pad
Controls the fan.
ON– The fan and compressor cycle on and off.
This results in wider variations of room
temperature and humidity. Normally
used when the room is unoccupied.
Note: The fan will continue to run for a short
time after the compressor cycles off.
OFF– The fan runs all the time, while the
compressor cycles on and off.
This switch must be set at OFF in order to use the fan
settings (on the mode control).
TIMER Pad
Turn on and use the INCREASE
DECREASE
you want the air conditioner to run before
turning off automatically. You can set the
timer to run for up to 24 hours. To cancel the
timer, press the TIMER pad until the display
time disappears.
Remote Control Signal Receiver
Make sure nothing is between the air
conditioner and the remote control
that could block the signal.
Make sure batteries are fresh and installed
correctly–see the Care and Cleaning section.
TIMER
TEMP
OFF
HIGH
FAN
MODE
COOL MED
LOW
ENERGY
SAVER
FAN
on/off
CIRCULAIRE
Remote Control
/
pads to set the number of hours
5