Quick Arming; To Add A User Or Change A User's Code - First Alert FA148C User Manual

Security Codes

Quick Arming

Note that if Quick Arming was programmed by the installer, you can
press the
system. You must always use the security code to disarm the system,
however.

To Add a User or Change a User's Code

Important: Temporary users of the system (e.g., babysitter, cleaning staff)
should not be shown how to use any system function they do not need to know,
such as bypassing protection zones.
You must make sequential key depressions for all steps in a
procedure within 2 seconds of one another (e.g., perform steps 1, 2,
and 3 below with no delay between steps), or else the entire entry is
aborted and must be repeated from its beginning.
1.
(Master Code)
2.
(User Number)
3.
(User's Code)
Changing the Master Code
Follow the procedure for changing a user's code, but enter user 02.
Additionally, when changing the Master code, you must perform step
3 twice with the same user code entry so that the new Master code
will be accepted by the system.
- 30 -
(cont'd)
# key in place of the security code when arming the
Enter 4-digit Master code, then press
+ 8
the 8
Example: Press 2 0 5 9 then 8
Enter user number.
Enter the 2-digit user number (03-16) for
the user you are adding or changing.
Enter user's code.
Enter the new 4-digit security code for
that user.
key.