To Change Your Master Code; Quick Arming; Phone (Voice) Module - First Alert FA142C User Manual

Duress Code
(Continued)
If a DURESS code
is assigned, check
here: -
To Change Your Master
Code

Quick Arming

Ask your installer if "Quick
Arming" is active for your
system; if so, check here:

Phone (Voice) Module

Ask your installer if your
system includes a phone
module; if so, check here:
SECURITY CODES (Continued)
The Duress code may be any 4-digit code assigned to User Number 8.
To program a Duress code:
Enter your Master Code + 8 + 8 + [desired 4-digit duress code].
The keypad will beep once.
Note: The Duress code must differ from the Master Code or any other User's Code.
To change the Duress code:
Enter the Master Code + 8 + 8 + [new 4-digit duress code].
To delete the Duress code:
Enter the Master Code + 8 + 8, and then stop. When the keypad beeps once it signifies
that the code has been deleted.
Enter the original Master code + 8 + 2 + New Master Code + New Master Code
again .
The keypad will beep 3 times, indicating acceptance of the new master code.
If your system supports "Quick Arming", the "#" key can be pressed in place of the
security code when arming the system. The security code is always required, however,
when disarming the system.
If your system includes a phone module, your installer will have programmed a 2-digit
phone access code for your system. Be sure to obtain this phone code from your installer.
Complete information regarding the use of this phone access feature is provided in a
separate manual entitled PHONE ACCESS USER'S GUIDE, which accompanies the
phone module.
– 1 1 –