HP Reliable Transaction Router Getting Started page 65

System responses begin with the characters %RTR-. Notes on
the procedure are enclosed in square brackets [ ]. For clarity,
commands you enter are shown in bold. You can view the status
of a transaction with the SHOW TRANSACTION command.
The exchange of messages you observe in executing these
commands illustrates RTR activity. You need to retain a similar
sequence in your own designs for starting up RTR and initiating
your own application.
You can use RTR SHOW and MONITOR commands to display
status and examine system state at any time from the CLI. For
more information on RTR commands, refer to the HP Reliable
Transaction Router System Manager's Manual.
The
rtr_receive_message
if no message is currently available. When using the
rtr_receive_message
/TIME=0 qualifier or TIMEOUT to poll for a message, if
you do not want your
block.
RTR Management
Note
command waits or blocks
command in the RTR CLI, use the
command to
rtr_receive_message
RTR Interfaces 4–11