Extron electronics MSW 4V rs User Manual page 19

3.
The Add Device window appears. On the Add Device window, select the appropriate
device and connection method.
Figure 15. Add Device Window
4.
From the remaining drop-down menus, select the appropriate port configuration
parameters (obtained from your system administrator). The defaults are 9600 baud
rate, no parity, 8 data bits, and one stop bit.
5. Click on the Connect button. The name of the selected device should appear in
green text with a check mark next to it.
6. Click on the Browse button to locate the appropriate firmware file for the device.
Select the file and click on the Open button. The file extension must be .S19.
CAUTION: Using a file with an incorrect extension may cause the unit to stop
functioning.
Figure 16. Choose Firmware File Window
MSW 4V rs and MSW 4SV rs • Control Software 13