Optical Device Ejector - HP ProLiant DL360 Generation 4 Maintenance And Service Manual

26 HP ProLiant DL360 Generation 4 Server Maintenance and Service Guide
3. Remove the optical device.
To replace the drive, slide the drive into the bay until it clicks.

Optical Device Ejector

1. Power down the server ("Powering Down the Server" on page 16).
2. Remove all hard drives ("Hard Drive" on page 21) and the hard drive blank
3. Eject the optical device (on page 25) or optical device blank (on page 24).
4. Extend or remove the server from the rack ("Extending the Server from the
5. Remove the diskette drive ("Diskette Drive" on page 23).
6. Use a T-10 Torx screwdriver to remove the screws that secure the optical
7. Press the tab on the side of the optical device ejector to release it from the
(on page 19).
Rack" on page 17).
device ejector to the server chassis.
chassis.