Maintenance; Operator Call Errors (By Led Blinking In Orange) - Canon i80 Reference Manual

1. MAINTENANCE

1-1. Error Display / Warning Indication
Service call errors are common to the i70 / PIXUS 50i.

(1) Operator call errors (by LED blinking in orange)

A new type of error indicated by LED blinking in orange 11 times has been added to the i70 /
PIXUS 50i errors (in red in the table below).
LED
blinking in
orange
2 times No paper.
3 times Paper jam.
6 times The print head is not
installed.
7 times The print head is not
installed properly.
(EEPROM data of the print
head is faulty.)
8 times Warning: The waste ink
absorber becomes almost
full (to approx. 95% of the
maximum capacity).
9 times The black or color ink tank
is not installed, or not
installed properly.
10 times Low battery
11 times A certain period of time
has elapsed without any
communication with a
connected digital camera /
video camera, or the
connected camera is not
supported.
Error
Set the paper, and press the
Resume/Cancel button.
Remove the jammed paper, and
press the Resume/Cancel button.
Install the print head, and close the
print head cover.
Re-install the print head, or with the
print head installed, turn the printer off
and on.
Pressing the Resume/Cancel button
will exit the error, and enable printing.
In repair servicing, replace the 4-item
set of the drain pack ass'y
(QL2-0194) and the 3 ink absorbers
(QC1-1210 / 1211 / 1212) at the same
time.
Install both the black and color ink
tanks. If they are installed, reseat
them properly.
Charge the battery, or connect the AC
adapter to resume printing.
Remove the cable(s), press the
Resume/Cancel button, and
re-connect the cable(s).
( 5 / 12 )
Solution Remarks
The service call error,
indicating the waste
ink absorber is full, is
likely to occur soon.
If the error persists
after the ink tanks are
seated properly, the
ink tank sensor is
likely to be faulty.