Table of Contents
Advertisement
2. Deck drive belt replacement
Set the gauge wheel
to the 1 l/2
position
(See page 34).
To replace
the drive belt, observe
the following.
-
1. Lower
the cutter
deck and remove
belt stoppers
A and B from the
FLANGE BOLT
LANGE BOLT
LT STOPPER A
(V-BELT DRIVEN STOPPER)
(P.T.O. CLUTCH LEVER BOLT)
-
2. Loosen the belt tension
adjust knob fully. Pull the belt at the left side
pulley and remove
it from the pulleys starting
with the one on the op-
posite
side.
BELT TiNSION
ADJUST
KNOB
Y
-
3. Remove
the belt from the cutter
deck driven
pulley.
-
4. Installation
sequence
is essentially
the
reverse
order
of removal.
Check that the belt is fully seated in the pulleys. After installing the
cutter
deck belt, check the belt slack as described
in page 31.
46
Advertisement
Table of Contents
