SLIP CLUTCH ADJUSTMENT
The slip clutch is factory preset to the correct torque
for protecting implement and tractor, and should
seldom require adjusting. Should adjustment be
needed, first check to be sure all spring lengths are
within 1/16" (1.6 mm). If necessary loosen nuts on
any springs that are unequal. Adjust all eight spring
retaining nuts 2/3 of a
turn
clutch slippage. If farther adjustment is necessary,
adjust in 1/3
increments or consult your HONDA
turn
Compact Tractor Dealer. Adjust only to provide
sufficient torque to prevent slippage under normal
conditions. When rocks, roots, etc., are present,
occasional slippage is normal for drivetrain
protection.
Approximate Working Width
...............................................................................................................................
Inside Housing Width
.................................................................................................................................................
Input RPM
Required P.T.O. HP Range
................................................................................................................................
Type Hitch
...........................................................................................................................
Rotor Shaft Speed
.....................................................................................................................
Gearbox rations
Deck Material
..................................................................................................................................
.......................................................................................................................................
Tilling Depth
..............................................................................................................................................
No. of Blades
.............................................................................................................................
Implement Weight
.................................................................................................................................
Shipping Weight
14
(4 flats on nut) and check
SPECIFICATIONS
..................................................................................................................
...................................................................................................................
5 1
540
11-40
3-point Cat. I
220 RPM
-
Input
1.461: 1
1
Lateral
-
1.687
:
5"
32
341 lbs.
390 lbs.